Find the top rated birding trails in Gilford, whether you're looking for an easy short birding trail or a long birding trail, you'll find what you're looking for. Click on a birding trail below to find trail descriptions, trail maps, photos, and reviews.
_146077_st.jpg)
I rode this trail several years ago, when it only extended 3-4 miles east from Wolfeboro. However, this summer I rediscovered the trail, which is now 12 miles long extending all the way to Turntable Park in Sanbornville (completed summer of 2017). What a beautiful trail it is now. I have ridden the trail 7-8 times this summer and am really hooked on it! The natural beauty from causeway lake crossings to very bucolic meadows & wetlands on the western end are some of the best I've ridden in awhile!
As far as trailside features, you have the lakeside Town of Wolfeboro with many restaurants and a great bike shop (Nordic Skier) in town. When leaving Wolfeboro you pass by the restored train depot (restrooms, tourist info) close to town. This first 2 miles tends to be busy with walkers, cyclists, and people sailing remote controlled sailboats by the soccer fields (kind of neat).
The trail continues east crossing Route 28 (kind of busy, but slower traffic with a painted crosswalk so cars tend to stop for pedestrians and cyclists) but still use caution because it is hard for motorists to see around the foliage and buildings close to the road.
After Route 28, the trail continues on to two lake crossings on old railroad causeways, this is where cyclists must start to pay attention for the rest of the trail in regards to the trail width. Due to the narrowness of the RR causeway, and the fact the tracks have not been removed, cyclists must ride on a wonderful hard dirt surface , BUT as good as the surface is, the path is less than 5 feet wide between the two rails. It's great if it's just you on the trail and no-one else is around, but the trail tends to be busy near Wolfeboro. Oncoming cyclists must be very careful passing each other, I have seen many have dismounted to pass, and also you must call out a friendly warning when approaching other users on the trail.
The trail alternates from between the rails to being beside the rails, and a few times the trail will meander away from the rails altogether (especially near Albee Beach (restrooms, beach). This is where CAUTION must be exercised when crossing rails. Signs on the trail suggest dismounting when you must cross the steel rails. Even though there are wooden platforms built up at the crossings, riders must hit the rails as close to a 90 degree angle as they can (I seem to do fine at 45 degrees with 26" x 2.1" tires). The 7-8 times I rode this trail I came across minimum of 4 cyclists that went down, and they had the bruises and cuts to show for it!! (BTW, I counted, and I think 30 crossings of the steel rails is pretty accurate count for the whole trail)
About 3 miles from Wolfeboro, you will cross State Route 109, a bit quieter than Rt 28, but traffic tends to be a little faster.
Also at this crossing there's the restored Fernald Station (parking,porta-potty), which is also home to the "Putt-Putt cars" (Cotton Valley Rail Trail Club). The putt-putt cars on this trail is very unique, they are motorized 2-person railcars that run from Fernald Station 8 miles to the west and State Route 16. I only saw them in action on one of my rides, they always give a big wave and travel at about 10mph. This is why the rails are still in place on this rail trail, and we owe the 80 member club a big thank you for the maintenance of overgrowth they perform.
Beyond Fernald Station, the trail continues west for another 8 miles to very busy SR 16. The trail continues to alternate "between the rails" and "beside the rails" for this section. This is my favorite section, the 8 mile stretch is very quiet and features natural meadows and wetlands, and there are just minor road crossings with one section of 4 miles with no road crossings at all - it is very enjoyable!!
The last mile before reaching busy State Route 16 features some pretty good short up and down whoopee hills. At Route 16, there is a parking area, and the Miss Wakefield Diner is just south of the trail on Route 16 (no need to cross the highway).
If you do decide to cross 16, be aware traffic travels faster than it's 55mph posted limit, and tends to carry a lot of traffic. Crossing the highway gives you one more mile of trail to downtown Sanbornville and it's Turntable Park, featuring an old turntable used to turn locomotives around. There are also restaurants located in Sanbornville. I have crossed the highway a few times, but in all honestly, the last mile on the other side of Route 16 is not that attractive, even though the Town of Sanbornville is kind of nice, it may not be worth crossing the busy road.
(There is parking on Route 16 on the west side of the highway, so a good option is to park on 16 and ride to Wolfeboro!)
Overall, this is a great and beautiful ride, just watch the rail crossings!
Went to this trail today. Waste of time. It’s only open for about .5 miles and stops. Nothing like the description of this trail.
Our family rode the trail from Wolfeboro to around mile marker 4, a while past the Cotton Valley Rail Trail Club on Rt. 109, in October 2018. There were a lot of great water views including a couple stretches with water on both sides, and winding parts through very pretty woods from about 1.5 miles just before Albee Beach onwards. The trail surface was very hard and not bumpy and presented no problem for hybrid-style bikes, basically as good as pavement (or even better than some paved trails I have been on that haven't been resurfaced recently). All of the crossings over the rails were clearly marked with signs instructing to walk your bikes and painted arrows indicating to do so at a right angle. After walking over many of them and them seeming very solid I began to slowly ride over them at 45 degree angles and never had a problem, and none of the several kids in my group did either. The parts of the trail in between the rails are narrow enough that you need to take extra care. If you are looking to go fast I wouldn't recommend this trail but if you are looking for a very scenic and leisurely ride I would highly recommend it. On the return ride I noticed that there were no signs for westbound bikers so this might explain some other peoples' complaints (although I still found the crossings vey obvious and good). I hope to return and ride the eastern portion of the trail another time.
It's early fall and a great time to ride this trail. The leaves are turning, the surface is dry and flat. There are many street crossings, most of them easy. We started in Raymond, off Onway Lake Road. If you map this using the RTC map, it gives you the address for the Gordon Cammett Recreation Area. If you turn in here, it takes you to a large parking lot and ball fields. This is where we started. The trail runs parallel to the ball fields but you can't see it from the parking lot. If you ride your bikes back up the hill you drove down, to the left at the top of the hill, there's a small cut-through. The trail is right there. If you look to your right, you'll see a tunnel (Manchester, or westbound). We rode to our left (Newfields, or eastbound). This is a 30-mile roundtrip ride. The trail has a few different surfaces, most well-packed and rideable with a hybrid. Some of the sandy patches and looser gravel (not many) might be more difficult with road bike tires. In Raymond, there is an old train station with train cars, a one-room schoolhouse, as well as stocks and a jail cell. There are 2 or 3 street crossings near various services if you need a drink or bite to eat. The trail ends at a parking lot, and fittingly, at the railroad tracks. There are no mileage markers along the trail. A trail kiosk in Epping will tell you the mileage to your destination in both directions.
Most of this trail is over packed earth, which is satisfactory, except following rain. The 4.5+ miles through Biddeford are poorly marked (download a map) and often hazardous. Scarborough marsh is beautiful and the rest of the trail is pleasant, often scenic. I rode the entire trail north one day and south the next. If I were to do it again, I would cut it into two smaller trails, and avoid Biddeford.
It's was a very cool weekend with the boys only see them 2 to 3 times a year ,getting older and family but always look forward to the next adventure, nice view of sawyer pond great big fire pit in front of the lean- to ,about a 2 1\2 hours to get to camp ,one place you should put on your to do list
Beautiful trail nice even gravel and sand walkway but WAY WAY WAY too much broken glass along the trail someone didn’t want dogs on the trail !!!
I started at the Massabesic Lake trailhead which offered plenty of parking as well as a beautiful start to my ride. There were no mile markers or any history signs on the trail so mileage is difficult to track. The first four to five miles of my ride were very rough with large rocks strewn all over the trail and three tunnels underneath roadways. The rocks in this section are all very well marked by orange spray paint, I just had to take my time on my hybrid bike. A hybrid bike will do just fine on the trail but a mountain bike would offer more confidence in this section.
After this first section of trail I found the rest of the trail to offer beautiful scenery as well as a much smoother ride. There are a fair share of road crossings but all but two are very quiet roads that had very little traffic. Raymond offers the perfect mid-trail stop to take pictures as well as a place to get food. Epping also offers more places to get refreshments. The last stretch of the trail from Epping to Newfields was my favorite part of the trail and offered an easy finish to my ride.
I rode the entire trail starting at Bug Light Park in South Portland and ending at Kennebunk; roughly 30 miles each way. I knew about the on road gaps and found them to be a positive as it added variety to the trail. The on road sections are fairly well marked and I only had an issue finding my way through Biddeford. The shoulders are very wide and I must say I found Maine drivers to be very courteous to me at every road crossing.
The off road sections of the trail are very well marked, shaded and very flat. I rode through forests and marshes and around residential neighborhoods. There is a fundraising effort to close one of the on road gaps on this trail. If that gap is closed I would give this trail five stars. I still highly recommend this trail as you can have a nice ride no matter what section you chose to ride.
I was delighted to read about the Cotton Valley Rail Trail from Wakefield to Wolfeboro. I picked up a copy of Rail-Trails, read up on the route and search Trail-link to read the reviews. I was aware of the switch over crossings on the trail and the dangers from what I read. Starting my ride in Wakefield at the Railroad Turntable I enjoyed a short ride to Route 16 and crossed over. I found the trail to be well maintained and walked over the first switch over crossing, I made a mental note that they might not be marked for hazards and continued riding. I was right! With the forest canopy and sun filtering through I came up on one with little notice and continue to cross and my back tire slipped out and I had crashed. Needless to say that ended my ride and caused an injury. I have ridden on many different surfaces and was shocked by what looked like an easy cross over. Please mark all switch over crossings as Hazards to avoid accidents. I am looking forward to riding this trail again after my recovery. If I had finished my ride I would have rated it a 5 Star, as I have heard it is a beautiful trail with a lot of great historical sites.
Disappointed to read that there is still a hazard on this trail. This could be so easy to fix by putting cement in between the rails or putting mats on the crossings. I will not go on this trail until this is fixed as I took a bad spill due to the rails.
TrailLink is a free service provided by Rails-to-Trails Conservancy (a non-profit) and we need your support!
Map Search
_155871_st.jpg)
_158934_st.jpg)
_0_st.jpg)
